Match 9mm Barrel for G19SKU: G19B
This high quality and high accuracy Match 9mm Barrel is designed to fit Glock 19. This replacement barrel is precision manufactured in the USA to the highest standards providing exceptional accuracy. Conventional rifling with a polished chamber and bore to perform well with lead, plated, and jacketed bullets. This barrel is ready-to-use and is a perfect replacement for your existing Glock barrel.
80 Percent Builder is your source for high quality, high accuracy aftermarket parts, components & accessories. We're constantly expanding and enhancing our products and services to continue to provide the highest quality and best deals for 80% gun parts and kits. We have a variety of videos available online to assist in setup and troubleshooting any questions you may have.
- Drop in fit for Glock Gen 1-4 & Glock Gen 5
- Machined from 416 stainless steel and heat treated to RC 41
- Fully supported chamber and improved feed ramp design
- Target crown and oversized lock up area
- Conventional rifling with a polished chamber and bore to perform well with lead, plated and jacketed bullets
- Reduces group size by 1/3
- 1:16 Twist Rate
“GLOCK” is a federally registered trademark of Glock, Inc. and is one of many trademarks owned by Glock, Inc. or Glock Ges.m.b.H. 80Pbuilder.com
is not affiliated with nor endorsed by Glock, Inc. or Glock Ges.m.b.H.
June 25, 2018This is a good barrel for the money and I might buy more. The overall fit and accuracy is as good as it get with this grade of barrel. The two that I have, have tight chambers so if you're a reloader you will want to check the OAL to make sure that the bullet doesn't strike in the lands of the rifling. I have some bullets that aren't a problem and some that are, it mostly depends on how the bullet nose is tapered. The first barrel I was having trouble with it not cycling until it locked up and I couldn't get the slide open. I was able to remove the slide because I had fallowed through with the trigger, it's a Glock thing where you have to pull the trigger to disassemble, as most will know. I could then remove the slide, disassemble the slide to remove the firing pin, and then remove the barrel so I could pry the cartridge out with my pocket knife. I then took the cartridges I had with me at the range and put them in the barrel one at a time and very few would drop free from the chamber on their own. Besides the bullet getting stuck in the chamber it could drive the bullet into the case deeper and create an even higher pressure than having the bullet resting on the rifling.
March 31, 2018Awesome quality at great price. Will be buying more and telling others of the awesome deal. Great job guys!
March 20, 2018Will not feed any type of round, but cannot be returned because I opened the package so I'm screwed.
March 12, 2018This is a very nice kit everything you need just remember to take your time building and watch the YouTube videos so you are familiar with the assembly also make sure to oil the gun well before firing
March 02, 2018The barrel is great quality with no machining marks or scratches
February 08, 2018Very fast delivery,I like the product.
February 04, 2018Perfect
January 04, 2018Great barrel only downside is after about 70 rounds its starting to show a little bit of wear from the slide, I think its slightly wider than spec which explains that.
December 22, 2017Excellent barrel! Great fit and finish. Good lockup area.
December 14, 2017It's a nice barrel, I did have to do a little bit of fitting.
You must log in to leave a review