Gunsmith Package for G19 30% OFFSKU: 80PB-G19SB
9mm for G19
Ready for custom mods
A blank canvas for your creations
Less than 20 available.
80PB-1 Slide/Barrel combo For Glock 19 G19 Bare Stainless Steel. This high quality and high accuracy Bare Stainless Steel 9mm Slide is designed to fit Glock 19 Gen 1-3. This slide was built specifically for your Glock and follows internal OEM specs. It is a great replacement for your existing or damaged slide. No internal parts are included.
80 Percent Builder is your source for high quality, high accuracy aftermarket parts, components & accessories. We're constantly expanding and enhancing our products and services to continue to provide the highest quality and best deals for 80% gun parts and kits. We have a variety of videos available online to assist in setup and troubleshooting any questions you may have.
- 17-4 Stainless Steel
- Fits Glock Gen 1-3
- Fits Polymer80
- Front/Rear Sight Cut
- No Serrations
- No Internal Parts Included
- Drop in fit for Glock Gen 1-4 & Glock Gen 5
- Machined from 416 stainless steel and heat treated to RC 41
- Fully supported chamber and improved feed ramp design
- Target crown and oversized lock up area
- Conventional rifling with a polished chamber and bore to perform well with lead, plated and jacketed bullets
- Reduces group size by 1/3
- 1:16 Twist Rate
This product is to be installed by a competent gunsmith.No liability is expressed or implied for damage or injury which may result from installation or use of this product.
“GLOCK” is a federally registered trademark of Glock, Inc. and is one of many trademarks owned by Glock, Inc. or Glock Ges.m.b.H. 80Pbuilder.com
is not affiliated with nor endorsed by Glock, Inc. or Glock Ges.m.b.H.
Experienced Gunsmith installation and 200 round break in period recommended
No reviews posted yet
You must log in to leave a review